How to Remove Cement Stains from Granite

Renovating the granite steps outside or changing the tiles or the countertop in the bathroom can create a mess and present you with problems, such as cement stains on the granite. White stains on granite may change its outlook completely. Even scrubbing the granite with a wired brush may not solve the problem. What you need is an acid based solution, and proper guidelines on how to use it to clean the cement stains from the granite. This article provides you with a list of all the things that you will need, and step-by-step instructions on how to use them.

Always remember to test the cleaning solution on an inconspicuous area of the granite to check for any damage that the solution may cause the granite. Also, wear safety goggles and rubber gloves when using the below mentioned chemicals.

Things that you will require:

·      Brick acid

·      Water

·      Washer

·      Sponge

·      Granite sealer

·      Paintbrush

·      Soft towel

Steps that you will need to take:

1.   To start off, grab the box of brick acid, and read the instructions on the box. Although brick acid can mostly be used without mixing it in water first, some brands may require diluting it with water.

2.   Pour a small amount of brick acid on the stained area of the granite. Let the acid remain in place for 15 to 20 minutes. In case the cement was still wet when you poured the brick acid, you can proceed to the next step after leaving it in place for 3 to 5 minutes only.

3.   If you are cleaning stains from the granite steps outside or any other exterior surface, soak the stained area with a washer set at 800 pounds per square inch. On the other hand, if you are in the process of removing cement stains from a granite surface in the kitchen or the bathroom, rinse it with cold water using a sponge.

4.   Once done, let the granite dry. Turn the fan on and leave the doors open if treating a granite surface inside. This will help it dry quickly.

5.   Next, you need to apply the granite sealer on the affected surface. Grab a paintbrush, read the instructions on the granite sealer box, and apply it to the surface according to the instructions.

6.   Wipe the surface with a soft towel. The granite surface should be as good as new!